Which commands will display the other routers with which the local router has established an adjacency with, including hold time and uptime parameters?

Which commands will display the other routers with which the local router has established an adjacency with, including hold time and uptime parameters?

  • show ip eigrp neighbors
  • show ip route
  • show adjacencies
  • show eigrp neighbors
Explanation:
The show ip eigrp neighbors command will display the neighboring EIGRP routers with which the local router has established an adjacency. It will also display hold time and uptime statistics. In this case, the uptime statistic refers to how long the adjacency has been established. A sample output of the show ip eigrp neighbors command is below.

Router2# show ip eigrp neigh
IP-EIGRP neighbors for process 100
H Address Interface Hold Uptime SRTT RTO Q Seq
(sec) (ms) Cnt Num
1 10.20.0.1 Se1 11 22:37:26 28 200 0 2
0 10.10.0.1 Se0 13 22:38:09 19 200 0 4

The show ip route command simply displays the routing table and does not provide neighbor information.

The other commands are not valid IOS commands.

Objective:
Layer 3 Technologies
Sub-Objective:
Configure and verify EIGRP neighbor relationship and authentication

Leave a comment