Refer to the exhibit. The NAT configuration applied to the router is as follows: Based on the configuration and the output shown, what can be determined about the NAT status within the organization?

Refer to the exhibit. The NAT configuration applied to the router is as follows:

ERtr(config)# access-list 1 permit 10.0.0.0 0.255.255.255 
ERtr(config)# ip nat pool corp 209.165.201.6 209.165.201.30 netmask 255.255.255.224 
ERtr(config)# ip nat inside source list 1 pool corp overload 
ERtr(config)# ip nat inside source static 10.10.10.55 209.165.201.4 
ERtr(config)# interface gigabitethernet 0/0 
ERtr(config-if)# ip nat inside 
ERtr(config-if)# interface serial 0/0/0 
ERtr(config-if)# ip nat outside

Based on the configuration and the output shown, what can be determined about the NAT status within the organization?

CCNA3 v7 – ENSA – Modules 6 – 8 WAN Concepts Exam Answers 02

CCNA3 v7 – ENSA – Modules 6 – 8 WAN Concepts Exam Answers 02

  • NAT is working.
  • Static NAT is working, but dynamic NAT is not.
  • Dynamic NAT is working, but static NAT is not.
  • Not enough information is given to determine if both static and dynamic NAT are working.
    Answers Explanation & Hints:

    There is not enough information given because the router might not be attached to the network yet, the interfaces might not have IP addresses assigned yet, or the command could have been issued in the middle of the night. The output does match the given configuration, so no typographical errors were made when the NAT commands were entered.

For more question and answers:

Click Here CCNA3 v7 – ENSA – Modules 6 – 8: WAN Concepts Exam Answers Full 100%

Leave a comment