If one end of an Ethernet connection is configured for full duplex and the other end of the connection is configured for half duplex, where would late collisions be observed?

If one end of an Ethernet connection is configured for full duplex and the other end of the connection is configured for half duplex, where would late collisions be observed?

  • on both ends of the connection
  • on the full-duplex end of the connection
  • only on serial interfaces
  • on the half-duplex end of the connection
    Answers Explanation & Hints:

    Full-duplex communications do not produce collisions. However, collisions often occur in half-duplex operations. When a connection has two different duplex configurations, the half-duplex end will experience late collisions. Collisions are found on Ethernet networks. Serial interfaces use technologies other than Ethernet.

For more question and answers:

Click Here CCNA 2 SRWE – Modules 1 – 4 – Switching Concepts, VLANs, and Inter-VLAN Routing Exam Answers Full 100%

Leave a comment