A network technician is attempting to configure an interface by entering the following command: SanJose(config)# ip address 192.168.2.1 255.255.255.0. The command is rejected by the device. What is the reason for this?

A network technician is attempting to configure an interface by entering the following command: SanJose(config)# ip address 192.168.2.1 255.255.255.0. The command is rejected by the device. What is the reason for this?

  • The command is being entered from the wrong mode of operation.
  • The command syntax is wrong.
  • The subnet mask information is incorrect.
  • The interface is shutdown and must be enabled before the switch will accept the IP address.
    Explanation:

    The wrong mode of operation is being used. The CLI prompt indicates that the mode of operation is global configuration. IP addresses must be configured from interface configuration mode, as indicated by the SanJose(config-if)# prompt.

For All Questions: ITN Final Exam Answers All in One Full 100% 2019

Leave a comment